Hi all,
I'm hoping someone can help me with which changes are needed in esys to achieve the following??
1) remove fog lights
2) rear lights active with DRL
3) which is more complicated....... see below:
I am in the process of fitting the bumper from the John Cooper Works car to my Cooper S.
The bumper is different in so much as the fog light assembly (which also contains the sidelights) is deleted and replaced with honeycomb grilles
The headlights on my car are LED headlights with an incorporated DRL LED 'horseshoe' ring. This headlight is also stock on the JCW car however, unlike the Cooper S it uses this DRL ring as its sidelights instead of the separate unit in the lower bumper like on the Cooper S.
Anyway without complicating things any further...currently this is the sequence associated with the headlight switch on the car as it stands:
1) headlight position switched to 'off' = LED DRL in headlight ON / rear lights OFF
2) headlight position switched to 'sidelight' = LED DRL in headlight OFF / LED sidelight in bumper ON / rear lights ON
3) headlight position switched to 'on' = LED DRL in headlight ON [with reduced brightness] / LED sidelight in bumper ON / LED dipped beam ON / rear lights ON
What I want to happen is for the car to replicate the JCW in terms of lighting which would be:
1) headlight position switched to 'off' = LED DRL in headlight ON / rear lights OFF
2) headlight position switched to 'sidelight' = LED DRL in headlight ON / rear lights ON
So in basic terms, I want my car to use the LED DRL's [which are built into the headlight] as the side lights, since my Cooper S will no longer have the fogs / sidelights in the lower bumper...
Can anyone shed any light on this?